How to Customize FXO and CP Tones for Local Country Settings on Cisco Voice Router

How to Customize FXO and CP Tones for Local Country Settings on Cisco Voice Router

According to the specifications of communication or similar institutions by the central office near every country of the world, there is a set call progress tone to manage the individual call signals within the country, which can be used to connect with central office or ISP The Cisco Voice Router equipped with FXO will come. With the default configuration that works in most countries, but in some countries where standard is not normal, you need to adjust FXO and call progress tone to match your central office or ISP by following the steps given below. 

Get specific country settings from your central office or your ISP: These settings should include frequency and rhythm for each signal, begging, ringback, reorder and out-of-service.

Access your router privilege level.

Create new Voice Class. See below example.

voice class custom-cptone cpt

dualtone busy

frequency 325 325

cadence 400 400

dualtone ringback

frequency 325 325

cadence 100 400

dualtone reorder

frequency 325 325

cadence 150 150

dualtone out-of-service

frequency 325 325

cadence 220 220

Go under the FXO port to assign a custom CPTone.

Voice-port 1/1/1

Disconnect dualtone mid-call in supervisory

Supervisory custom-septon cpt

Add additional settings.

no comfort-noise

timeouts call-disconnect 1

timeouts wait-release 1

timing hookflash-out 50

Connection Plar OPX ……(Extension of operator or Voicemail system)

caller-id enable

Creative Commons License

Leave a Reply